specification control drawing tyco electronics corporation 305 constitution drive menlo park, ca 94025, usa raychem products coaxial soldersleeve* device with pre-installed lead solid wires unless otherwise specified dime nsions are in millimeters. inches dimensions are in between brackets. document no: b-041-ga-n tolerances: 0.00 n/a 0.0 n/a 0 n/a angles: n/a roughness in micron tyco electronics reserves the right to amend this drawing at any time. users should evaluate the suitability of the product for their application. date: nov. 23, 1998 doc issue: 3 drawn by: r. mapalo replaces: b021xyn dcr number: d981933 prod. rev. see table scale: none size: a sheet: 1 of 1 if this document is printed it becomes unc ontrolled. check for the latest revision. part product product dimensions ?ga? = wire gauge name revision a min b min c min l max k min (awg) b-041-24-n d 24 b-041-26-n d 4.4 2.8 1.6 30 150 26 b-041-28-n d (0.175) (0.110) (0.060) (1.180) (5.900) 28 b-041-30-n d 30 cable dimensions d e f min (g 0.02) (m 0.02) 1.7 (0.065) to 1.5 (0.060) to 0.3 16 6 4.4 (0.175) 2.8 (0.110) (0.012) (0.630) (0.235) material 1. & 6. insulation sleeve: heat-shrinkable, radiation cro ss-linked modified polyvinylidene fluoride. transparent blue. 2. & 5. solder preforms with flux: solder: type sn63 per ansi j-std-006. flux: type rol1 per ansi j-std-004. 3., 4. & 7. meltable rings: ther mally stabilized thermoplastic. 8. conductor lead: awg ga (see table). mil-w-81822/13-ga-9. etfe insulated silver plated solid conductor. color: white. 9. ground lead: mil-w-81822/13-ga-g. etfe insulated, silverplat ed, solid conductor. color: blue. ga= gauge per table. application a. the parts covered by this scd are for use in terminating the primary conductor and the brai ded shield of a coaxial cable having tin or silverplated conductor and shield, rated fo r at least 125 c and meeting th e dimensional requirements listed . b. parts will meet the requirements of raychem specifi cation rt-1404 when installed per raychem rpip-500-03. for best results, prepare the cable as shown:
|